subpart_subject: "Applicability and General Provisions"
section_number: "1066.5"
section_subject: "Overview of this part 1066 and its relationship to the standard-setting part."
cfr_reference: "40 CFR 1066.5"
title_name: "Title 40"
title_subject: "Protection of Environment"
parts_covered: "Part 1060 to End"
revised_date: "Revised as of July 1, 2019"
publication_date: "As of July 1, 2019"
contains_description: "Containing a codification of documents of general applicability and future effect"
publication_info: "Published by the Office of the Federal Register National Archives and Records Administration as a Special Edition of the Federal Register"
---
(a)This part specifies procedures that can apply generally to testing various categories of vehicles. See the standard-setting part for directions in applying specific provisions in this part for a particular type of vehicle. Before using this part's procedures, read the standard-setting part to answer at least the following questions:
(2)Should I warm up the test vehicle before measuring emissions, or do I need to measure cold-start emissions during a warm-up segment of the duty cycle?
(3)Which exhaust constituents do I need to measure? Measure all exhaust constituents that are subject to emission standards, any other exhaust constituents needed for calculating emission rates, and any additional exhaust constituents as specified in the standard-setting part. See 40 CFR 1065.5 regarding requests to omit measurement of N2O and CH4 for vehicles not subject to an N2O or CH4 emission standard.
(4)Do any unique specifications apply for test fuels?
(5)What maintenance steps may I take before or between tests on an emission-data vehicle?
(6)Do any unique requirements apply to stabilizing emission levels on a new vehicle?
(7)Do any unique requirements apply to test limits, such as ambient temperatures or pressures?
(8)What requirements apply for evaporative and refueling emissions?
(9)Are there any emission standards specified at particular operating conditions or ambient conditions?
(10)Do any unique requirements apply for durability testing?
(b)The testing specifications in the standard-setting part may differ from the specifications in this part. In cases where it is not possible to comply with both the standard-setting part and this part, you must comply with the specifications in the standard-setting part. The standard-setting part may also allow you to deviate from the procedures of this part for other reasons.
(c)The following table shows how this part divides testing specifications into subparts: